Telecomanda DIM/CCT HX-RFBT02B 2.4G

. Wireless remote control code value setting method

The number of controllers and remote controls in one system is unlimited. 2.4G Smart system has one unique RF code for communication. Each controller and each remote control can remember only one RF code, recorded in the first programing. New RF code can be recorded after delete the old one.

Tips: matching code and clearing code operations both use the same button , the 2 operations is performed alternately, which can be distinguished by the color of the color ring light:

Matching code operation- Red;

Clearing code operation- Green.

Code matching operation: the receiver will only be controlled by the value code remote control.

Code clearing operation: that the original code value of the receiver will be cleared and returned to the factory state. Then it can be controlled by any compatible remote control, also can be paired to a new code.

Code learning operation between remote controls: Used to unify system code values or copy a new remote control.

Since each remote control has its own unique RF code at the time of delivery, when there are multiple remote controls in one system, one of them must be selected as a main, and other remote controls should copy its RF code.

1) Main remote control: Press and hold  (RGB ON/OFF key) for 5 seconds ( the color of color ring light on the remote control can be red or green). The RF indicator of the remote control will flash quickly, means it enters the sending code transmission status.

2) New remote control: Press and hold    (RGB Mode key) for 5 seconds, indicator will turn from 100% to off and the color of color ring light on the remote control will be blue, means it enters learning code status.

3) The RF Indicator of the new remote control flash 3 times after successful code learning.

Remote control RF code learning from controllers

1) Turn off the power supply of the controllers.

2) Press and hold  (RGB Mode key) for 5 seconds until indicator of remote control turns off.

3) Turn on the power supply of the controllers. The RF indicator of the remote control flashes 3 times after successful code learning.

Note: The distance from controllers to remote controls should be less than 2 meters.

Restoring factory settings of remote control

1) Press and hold  (RGB Mode key) for 20 seconds until the RF indicator of remote control process the state as 100% -off-100%( the color ring light state as off-blue-off at the meanwhile).

2) Press  (RGB ON/OFF key) to submit and finish the operation. Indicator of the remote control will flash three times after successful operation.

About installation of remote control’s bracket:

1.Accessories include: bracket 1pc, 3M foam sponge glue 1pc, screw 2pcs, expansion tube 2pc.

2. There are 2 options for bracket installation:

1) Using screw and expansion tube make drilling installation (suitable for uneven and ash surface);

2) Using 3M foam sponge glue make free drilling installation (suitable for flat no ash surface).

6. Compatible family

Product information for placing order